Siemens SINUMERIK 840Di Diagnostic Manual page 272

Overview of Alarms
NCK alarms
15330 Channel %1 block %2 invalid block number as search target
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Syntax error! Positive integers are allowed as block numbers. Block numbers must be preceded by ":"
and subblocks by an "N".
Reaction: Alarm display.
Remedy: Repeat the input with corrected block number.
Program Clear alarm with the Delete key or NC START.
Continuation:
15340 Channel %1 block %2 invalid label as search target
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Syntax error! A label must have at least 2 but no more than 32 characters, and the first two characters
must be alphabetic or underscore characters. Labels must be concluded with a colon.
Reaction: Alarm display.
Remedy: Repeat the input with corrected label.
Program Clear alarm with the Delete key or NC START.
Continuation:
15350 Channel %1 block %2 search target not found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified program has been searched to the end of the program without the selected search
target having been found.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check the part program, change the block search (typing error in the part program) and restart the
search.
Program Clear alarm with the RESET key. Restart part program
Continuation:
15360 Channel %1 illegal target of block search (syntax error)
Parameters: %1 = Channel number
Definitions: The specified search target (block number, label or string) is not allowed in block search.
Reaction: Alarm display.
Remedy: Correct target of block search.
Program Clear alarm with the Delete key or NC START.
Continuation:
15370 Channel %1 target of block search not found
Parameters: %1 = Channel number
Definitions: In a block search, an impermissible search target has been specified (e.g. negative block number).
Reaction: Alarm display.
Remedy: Check the specified block number, label or character string. Repeat entry with correct search target.
Program Clear alarm with the Delete key or NC START.
Continuation:
2-272
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006