Siemens SINUMERIK 840Di Diagnostic Manual page 63

11/2006
4611 Invalid handwheel input for handwheel %1
Parameters: %1 = Handwheel input
Definitions: The handwheel input for handwheel %1 requested through machine date
$MN_HANDWHEEL_INPUT is not available for 840D systems. With 840D systems, a maximum of 3
handwheels can be linked directly (1st and 2nd directly to 840D HW, 3rd handwheel through free
encoder input).
Reaction: Interface signals are set.
Alarm display.
Remedy: Configure machine date $MN_HANDWHEEL_INPUT for a valid input for the corresponding
handwheel
Program Switch control OFF - ON.
Continuation:
4620 Invalid handwheel module for handwheel %1
Parameters: %1 = Handwheel module
Definitions: The handwheel module for handwheel %1 requested through machine date
$MN_HANDWHEEL_MODULE is not available for 802D systems. An 802D system is always
regarded as a module. For this reason, $MN_HANDWHEEL_MODULE = 1 must always be set for
handwheels directly linked with 802D systems.
Reaction: Interface signals are set.
Alarm display.
Remedy: Set machine date $MN_HANDWHEEL_MODULE = 1 for the corresponding handwheel.
Program Switch control OFF - ON.
Continuation:
4621 Invalid handwheel input for handwheel %1
Parameters: %1 = Handwheel input
Definitions: The handwheel input for handwheel %1 requested through machine date
$MN_HANDWHEEL_INPUT is not available for 802D systems. With 802D systems, a maximum of 2
handwheels can directly be linked.
Reaction: Interface signals are set.
Alarm display.
Remedy: Configure machine date $MN_HANDWHEEL_INPUT for a valid input for the corresponding
handwheel
Program Switch control OFF - ON.
Continuation:
4630 Invalid handwheel module for handwheel %1
Parameters: %1 = Handwheel module
Definitions: The reference in $MN_HANDWHEEL_MODULE for a corresponding entry in machine date array
$MN_HANDWHEEL_LOGIC_ADDRESS[] necessary for the configuration of PROFIBUS handwheels
is not available.
Reaction: Interface signals are set.
Alarm display.
Remedy: Configure the machine data $MN_HANDWHEEL_MODULE for the corresponding PROFIBUS
handwheel so that there is a valid reference to an entry in the machine data array
$MN_HANDWHEEL_LOGIC_ADDRESS[].
Program Switch control OFF - ON.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-63