Siemens SINUMERIK 840Di Diagnostic Manual page 425

11/2006
26015 Axis %1 machine data %2[%3] invalid value
Parameters: %1 = Axis name, spindle number
%2 = String: MD identifier
%3 = Index: MD array
Definitions: Machine data includes a value that is not valid.
Reaction: NC not ready.
The NC switches to follow-up mode.
Mode group not ready, also effective for single axes
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Repeat entry with correct value and then Power On.
Program Switch control OFF - ON.
Continuation:
26016 Axis %1 machine data %2 invalid value
Parameters: %1 = Axis name, spindle number
%2 = String: MD identifier
Definitions: Machine data includes a value that is not valid.
Reaction: NC not ready.
The NC switches to follow-up mode.
Mode group not ready, also effective for single axes
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Repeat entry with correct value and then Reset.
Program Clear alarm with the RESET key in all channels of this mode group. Restart part program.
Continuation:
26017 Axis %1 machine data %2[%3] invalid value
Parameters: %1 = Axis name, spindle number
%2 = String: MD identifier
%3 = Index: MD array
Definitions: Machine data includes a value that is not valid.
Reaction: NC not ready.
The NC switches to follow-up mode.
Mode group not ready, also effective for single axes
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Repeat entry with correct value and then Reset.
Program Clear alarm with the RESET key in all channels of this mode group. Restart part program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-425