Siemens SINUMERIK 840Di Diagnostic Manual page 547

11/2006
61402 Channel %1 block %2: Probe collision, traversing path limitation through
software limit position
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE977
For the measuring variant Measure web/shaft, the position path in the plane was limited by the
software limit position. The probe switched in the following infeed along the infeed axis.
Remedy: Check programmed position regarding software end position.
61403 Channel %1 block %2: Internal cycle error during frame calculation.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Call the SIEMENS hotline
61404 Channel %1 block %2: Internal cycle error during tool offset.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check the dependent tool specifications.
61405 Channel %1 block %2: tool environment does not exist in _TENV
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Correct the names or create this environment.
61406 Channel %1 block %2: check DL number in _DLNUM
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check the number of additive offset and setup offset.
Check parameter _DLNUM.
61407 Channel %1 block %2: check 7th digit and higher of _KNUM
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The 6th position of _KNUM includes invalid values.
Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check the number of additive offset and setup offset.
Check parameter _KNUM.
61408 Channel %1 block %2: total offsets not present
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Set MD 18080, Bit 8=1
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-547