Siemens SINUMERIK 840Di Diagnostic Manual page 191

11/2006
12730 Channel %1 block %2 no valid transformation machine data
parameterized
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The machine data $MC__TRAFO_TYPE_1, $MC_TRAFO_AXES_IN_1[1],
$MC_TRAFO_AXES_IN_2[1] are incorrectly set for G07.1, G12.1.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Enter valid transformation identifier for TRACYL in $MC__TRAFO_TYPE_1 and the rotary axis
number in $MC_TRAFO_AXES_IN_1[1] or $MC_TRAFO_AXES_IN_2[1].
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12740 Channel %1 block %2 modal macro call %3 not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source string
Definitions: When calling a modal macro no other modal macro, modal cycle or modal subroutine may be active.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14000 Channel %1 block %2 illegal end of file
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm 14000 is output in the following situations:
- Parts program was not terminated with M30, M02 or M17.
- Executing from external: Download was aborted (e.g. because HMI wasswitched off).
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - End parts program with M30, M02 or M17 and start parts program.
- Executing from external: If the download for the selected program was aborted,
the default program _N_MPF0 is automatically selected with RESET
The selection of the user program must be repeated after that.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-191