Siemens SINUMERIK 840Di Diagnostic Manual page 785

11/2006
310703 Axis %1 drive %2 monitoring cycle time invalid
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: Monitoring cycle MD 5002: MONITOR_CYCLE_TIME (monitoring cycle) is invalid.
Reaction: NC not ready.
The NC switches to follow-up mode.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please refer to the drive functions "FB/DB1" MD 1002.
Program Switch control OFF - ON.
Continuation:
310704 Axis %1 drive %2 speed controller cycle times of axes differ
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: The speed controller cycle MD 5001: SPEEDCTRL_CYCLE_TIME must be identical for both axes on
2-axis modules.
Reaction: NC not ready.
The NC switches to follow-up mode.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Set an identical speed controller cycle MD 5001: SPEEDCTRL_CYCLE_TIME for both axes.
Program Switch control OFF - ON.
Continuation:
310705 Axis %1 drive %2 monitoring cycle times of axes differ
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: The monitoring cycle MD 5002: MONITOR_CYCLE_TIME must be identical for both axes on 2-axis
modules.
Reaction: NC not ready.
The NC switches to follow-up mode.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify MD 5002: MONITOR_CYCLE_TIME for both axes.
Program Switch control OFF - ON.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
SIMODRIVE alarms
2-785