Siemens SINUMERIK 840Di Diagnostic Manual page 574

Overview of Alarms
NCK alarms
61985 Channel %1 block %2: Program name for drilling positions missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61986 Channel %1 block %2: Program pocket milling missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61987 Channel %1 block %2: Program drilling positions missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61988 Channel %1 block %2: Program name for pocket milling missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61989 Channel %1 block %2: D1 is not programmed as active tool cutting edge
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
62000 Channel %1 block %2:
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Reaction: Alarm display.
Remedy: --
Program Clear alarm with the Delete key or NC START.
Continuation:
62000 Channel %1 block %2: Insert new tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Please load new tool.
Remedy: --
62100 Channel %1 block %2: No drilling cycle active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No modal drilling cycle has been called before the drilling pattern cycle call. Alarm triggered by
following cycles: HOLES1, HOLES2.
Remedy: Check whether a drilling cycle was called prior to calling the drilling pattern cycle.
2-574
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006