Siemens SINUMERIK 840Di Diagnostic Manual page 278

Overview of Alarms
NCK alarms
16000 Channel %1 block %2 invalid value for lifting direction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: During the "rapid lift from contour" (keyword: LIFTFAST), a code value for the lifting direction
(keyword: ALF=...) which lies outside the permissible range (permissible value range: 0 to 8) was
programmed .
With active cutter radius compensation:
Code numbers 2, 3 and 4 cannot be used in G41
Code numbers 6, 7 and 8 cannot be used in G42 because they code the direction to the contour.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program the lifting direction under ALF=... within the permissible limits.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16005 Channel %1 block %2 invalid value for lifting distance
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Mistake in programming: the value for the lifting path must not be negative.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16010 Channel %1 block %2 machining stop after lift fast
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: LIFTFAST without interrupt routine (Asup) has been programmed. The channel is stopped after the
lift motion has been carried out.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: After the channel stop, the axes must be retracted manually in JOG and the program aborted with
Reset.
Program Clear alarm with the RESET key. Restart part program
Continuation:
16015 Channel %1 block %2 wrong axis identifier %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: Axis names from different coordinate systems were used to program axes for LIFTFAST. The
retraction movement is no longer clear.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Use axis names from one coordinate system.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-278
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006