Siemens SINUMERIK 840Di Diagnostic Manual page 228

Overview of Alarms
NCK alarms
14250 Channel %1 block %2 negative pole radius
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In redefining the pole with G110, G111 or G112 in polar coordinates, the pole radius specified under
keyword RP=... is negative. Only positive absolute values are permitted.
Definition of terms:
- Specification of end of block point with polar angle and polar radius, referring to the current pole
(preparatory functions: G00/G01/G02/G03).
- New definition of the pole with polar angle and pole radius, referring to the reference point selected
with the G function. G110 ... last programmed point in the plane, G111 ... zero point of the current
work, G112 ... last pole
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC part program. Permissible inputs for the pole radius are only positive, absolute values
that specify the distance between the reference point and the new pole. (The direction is defined with
the pole angle AP=...).
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14260 Channel %1 block %2 pole angle too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In redefining the pole with G110, G111 or G112 in polar coordinates, the value range of the pole angle
specified under keyword AP=... has been exceeded. It covers the range from -360 to +360 degrees
with a resolution of 0.001 degrees.
Definition of terms:
- Specification of end of block point with polar angle and polar radius, referring to the current pole
(preparatory functions: G00/G01/G02/G03).
- New definition of the pole with polar angle and pole radius, referring to the reference point selected
with the G function. G110 ... last programmed point in the plane, G111 ... zero point of the current
work, G112 ... last pole
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct NC part program. The permissible input range for the polar angle is between the values -360
degrees and +360 degrees with a resolution of 0.001 degrees.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14270 Channel %1 block %2 pole programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: When defining the pole, an axis was programmed that does not belong to the selected processing
level. Programming in polar coordinates always refers to the plane activated with G17 to G19. This
also applies to the definition of a new pole with G110, G111 or G112.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC part program. Only the two geometry axes may be programmed that establish the
current machining plane.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-228
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006