Siemens SINUMERIK 840Di Diagnostic Manual page 275

11/2006
15460 Channel %1 block %2 syntax error with modal function
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The addresses programmed in the block are not compatible with the modal syntax-determining G
function.
Example:
N100 G01 ... I .. J.. K.. LF
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the displayed block and ensure that the G functions and addresses in the block are in
agreement.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
15500 Channel %1 block %2 illegal angle of shear
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The function CSHEAR has been called with an illegal (impossible) angle of shear, e.g. when the sum
of angles between the axis vectors is greater than 360 degrees.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program the angle of shear in accordance with the geometrical conditions of the machine and
workpiece system.
Program Clear alarm with the RESET key. Restart part program
Continuation:
15700 Channel %1 block %2 illegal cycle alarm number %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Cycle alarm number
Definitions: A SETAL command has been programmed with a cycle alarm number less than 60 000 or greater
than 67 999.
Alarm reactions of Siemens standard cycles:
Nos. 61,000 -61,999: Interpreter stop; delete with Reset
Nos. 62 000 - 62 999: Compensation block; delete with NC Start
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program alarm number in the SETAL instruction in the correct range.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-275