Siemens SINUMERIK 840Di Diagnostic Manual page 102

Overview of Alarms
NCK alarms
10249 [up to SW 3.x only] Mode group %2 channel %1: mode change command
canceled
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: An error occurred while a mode change command was active, with the result that the sequence could
not be continued.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Press RESET and select the mode again.
Program Clear alarm with the RESET key in all channels of this mode group. Restart part program.
Continuation:
10250 [up to SW 3.x only] Channel %1 reorganization of block processing not
possible at this time
Parameters: %1 = Channel number
Definitions: REORG is not possible at present.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: --
Program Clear alarm with the RESET key. Restart part program
Continuation:
10251 [up to SW 3.x only] Channel %1
Parameters: %1 = Channel number
Definitions: REORG is not possible at present.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Press RESET.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10252 [up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Internal sequence error. REORG is not possible at present.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Press RESET.
Program Clear alarm with the RESET key. Restart part program
Continuation:
2-102
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006