Siemens SINUMERIK 840Di Diagnostic Manual page 500

Overview of Alarms
NCK alarms
61108 Channel %1 Block %2: Values for parameters _RAD1 and _DP1 not
permissible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameters _RAD1 and _DP for defining the path for the depth infeed have been incorrectly
specified. Alarm triggered by following cycles: POCKET3, POCKET4.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Modify parameter.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61109 Channel %1 Block %2: Parameter _CDIR incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The value of the parameter for the cutting direction _CDIR has been incorrectly defined. Alarm
triggered by following cycles: POCKET3, POCKET4.
Remedy: Change parameter _CDIR.
61110 Channel %1 Block %2: Finishing allowance at bottom > depth infeed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The finishing allowance at the base has been specified greater than the maximum depth infeed. Alarm
triggered by following cycles: POCKET3, POCKET4.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Either reduce finishing allowance or increase depth infeed.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61111 Channel %1 Block %2: Infeed width > Tool diameter
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed infeed width is greater than the diameter of the active tool. Alarm triggered by
following cycles: CYCLE71, POCKET3, POCKET4.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Infeed width must be reduced.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61112 Channel %1 Block %2: Tool radius negative
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The radius of the active tool is negative. This is illegal. Alarm triggered by following cycles: CYCLE72,
CYCLE76, CYCLE77, CYCLE90.
Remedy: Change the tool radius.
2-500
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006