Siemens SINUMERIK 840Di Diagnostic Manual page 86

Overview of Alarms
NCK alarms
6700 Channel %1 value of the machine data %2%3 is too low
Parameters: %1 = Channel number
%2 = MD identifier
%3 = If required, field index
Definitions: The machine data $MC_MM_PROTOC_NUM_ETP_STD_TYP specifies the number of default event
types for the protocol users. However, more types are used than configured.
Reaction: Alarm display.
Remedy: Increase machine data $MC_MM_PROTOC_NUM_ETP_STD_TYP.
Program Clear alarm with the Delete key or NC START.
Continuation:
7000 Too many compile cycle alarms defined
Definitions: Too many alarms are defined for the compile cycles. On powering up, the quantity was exceeded
when defining a new CC alarm.
Reaction: Alarm display.
Remedy: Apart from reducing the number of CC alarms, no remedial measures are possible at the present time.
(contact SIEMENS AG, System Support for A&D MC products, Hotline (Tel.: see alarm 1000)
Program Clear alarm with the Delete key or NC START.
Continuation:
7010 Range of MMC alarm numbers for compile cycles exceeded
Definitions: A fixed quantity of alarm numbers (100) is reserved for the compile cycles. This has been exceeded
when defining a new CC alarm. (The valid range is between 0 and 4999).
Reaction: Alarm display.
Remedy: Define the CC alarm numbers in the valid range from 0 to 4999.
Program Clear alarm with the Delete key or NC START.
Continuation:
7020 Compile cycle alarm number has not been defined
Definitions: The alarm ID used by the manufacturer is not known to the system. This was not allocated when the
alarms were generated.
Reaction: Alarm display.
Remedy: The alarm can have 2 possible causes:
- The alarm number has not been defined. A definition must still be made.
- The call parameter used is not the same as the one transferred by the NCK.
Program Clear alarm with the Delete key or NC START.
Continuation:
2-86
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006