Siemens SINUMERIK 840Di Diagnostic Manual page 91

11/2006
8034 Option 'activation of axis containers' not set
Definitions: The option for activating the axis container function in MD $MN_AXCONF_LOGIC_MACHAX_TAB is
not enabled.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Buy option
- Do not configure any containers
Program Clear alarm with the RESET key. Restart part program
Continuation:
8036 Option: it is not allowed to set different IPO cycles or position control
cycles with NCU link.
Definitions: The option for activating the FAST_IPO_LINK has not been set. For NCU link, all Ipo or position
control cycles must then be equal (see FAST-IPO-LINK description).
Reaction: NC not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: - Buy option
- Do not activate different Ipo or position control cycles (see MN_IPO_SYSCLOCK_TIME_RATIO and
MN_POSCTRL_SYSCLOCK_TIME_RATIO).
Program Switch control OFF - ON.
Continuation:
8037 Option 'APC activation' not set
Definitions: Function 'Advanced Positioning Control' (APC) has been activated in the drive, although the
corresponding option was not set.
Reaction: NC not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: - Buy option
- Deactivate function 'Advanced Positioning Control' (APC) in the drive
Program Switch control OFF - ON.
Continuation:
8038 Option 'activation of more than %1 lead link axes' not set
Parameters: %1 = Number of axes
Definitions: The option for the number of lead link axes does not match the number of configured axes in the MD
$MA_AXCONF_ASSIGN_MASTER_NCU.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Buy option
- Configure fewer lead link axes
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-91