Siemens SINUMERIK 840Di Diagnostic Manual page 559

11/2006
61604 Channel %1 block %2: Active tool violates programmed contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Contour violation in the relief cut elements due to the tool clearance angle of the tool used. Alarm
triggered by following cycle: CYCLE95.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Use a different tool or check the contour subroutine.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61605 Channel %1 block %2: Contour incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Illegal relief cut element detected. Alarm triggered by following cycles: CYCLE76, CYCLE77,
CYCLE95.
Remedy: Check contour program.
61606 Channel %1 block %2: Error during contour preparation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An error has been found on conditioning the contour. This alarm is always related to one of NCK
alarms 10930...10934, 15800 or 15810. Alarm triggered by following cycle: CYCLE95.
Remedy: Check contour subroutine.
61607 Channel %1 block %2: Starting point incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The starting point reached before the cycle call does not lie outside the rectangle described by the
contour subroutine. Alarm triggered by following cycle: CYCLE95.
Remedy: Check starting point prior to cycle call.
61608 Channel %1 block %2: Incorrect tool point direction programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE94, CYCLE96.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: A cutting edge position 1...4, matching the undercut form, must be programmed.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61609 Channel %1 block %2: Shape incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE94, CYCLE96, LONGHOLE, POCKET3, SLOT1.
Remedy: Check parameter for the undercut form or groove form or pocket.
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-559