Siemens SINUMERIK 840Di Diagnostic Manual page 103

11/2006
10253 [up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Internal sequence error. REORG is not possible at present.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Press RESET.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10254 [up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Interpreter output negative acknowledgement for REORG.
Reaction: Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Press RESET.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10255 [up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Internal sequence error. REORG is not possible at present.
Reaction: Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Press RESET.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10256 [up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Internal sequence error. REORG is not possible at present - program abort.
Reaction: Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Press RESET.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-103