Siemens SINUMERIK 840Di Diagnostic Manual page 204

Overview of Alarms
NCK alarms
14080 Channel %1 block %2 jump destination %3 not found
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Jump destination
Definitions: In conditional and unconditional jumps, the jump destination within the program must be a block with
a label (symbolic name instead of block number). If no jump destination has been found with the given
label when searching in the programmed direction, an alarm is output.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Check NC part program for the following possible errors:
1. Check whether the target designation is identical with the label.
2. Is the jump direction correct?
3. Has the label been terminated with a colon?
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14082 Channel %1 block %2 label %3 program section not found
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Start or end label
Definitions: The start point for repetition of the program part with CALL <program name> BLOCK <start label> TO
<end label> has not been found or the same program part repetition has been called recursively.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Check the start and end labels for programming repetition in the user program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14085 Channel %1 block %2 instruction not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The instruction 'TML()' may only be used in the subprogram, which replaces the T command.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14088 Channel %1 block %2 axis %3 doubtful position
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: An axis postion larger than 3.40e+38 increments has been programmed. This alarm can be
suppressed with bit 11 in $MN_SUPPRESS_ALARM_MASK.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-204
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006