Siemens SINUMERIK 840Di Diagnostic Manual page 501

11/2006
61113 Channel %1 Block %2: Parameter _CRAD too large for corner radius
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameter for the corner radius _CRAD has been specified too large. Alarm triggered by following
cycle: POCKET3.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Parameter must be reduced.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61114 Channel %1 Block %2: Machining direction G41/G42 incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The machining direction of the cutter radius compensation G41/G42 has been incorrectly selected.
Alarm triggered by following cycle: CYCLE72.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Change machining direction.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61115 Channel %1 Block %2: Approach or retract mode(straight / circle / plane /
space) incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The approach or retract mode to/from the contour has been incorrectly defined. Alarm triggered by
following cycle: CYCLE72.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Check parameter _AS1 or _AS2.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61116 Channel %1 Block %2: Approach or retract path = 0
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The approach or retract path has been specified with zero. Alarm triggered by following cycle:
CYCLE72.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Check parameter _LP1 or _LP2.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-501