Siemens SINUMERIK 840Di Diagnostic Manual page 229

11/2006
14280 Channel %1 block %2 polar coordinates programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The end point of the displayed block has been programmed both in the polar coordinate system (with
AP=..., RP=...) and in the Cartesian coordinate system (axis addresses X, Y,...).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC part program - the axis motion may be specified in one coordinate system only.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14290 Channel %1 block %2 polynominal degree greater than 5 programmed
for polynominal interpolation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A polynominal degree greater than five was programmed for the polynominal interpolation. You can
only program polynomials up to the 5th degree.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14300 Channel %1 block %2 overlaid handwheel motion activated incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Handwheel override has been called up incorrectly:
- 1. For positioning axes:
- Handwheel override programmed for indexing axes,
- No position programmed,
- FA and FDA programmed for the same axis in the block.
- 2. For contouring axes:
- No position programmed,
- G60 not active,
- 1. 1st G group incorrect (only G01 to CIP).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14310 Handwheel %1 configuration incorrect or inactive
Parameters: %1 = Handwheel number
Definitions: - The inputs are using a drive with a drive number that does not exist or
- an inactive drive for assignment of the handwheel (ENC_HANDWHEEL_MODULE_NR) or
- an axis is using a measuring circuit which does not exist for the drive hardware.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Check input configuration (machine data)
and/or drive hardware. Power-up is interrupted.
Program Switch control OFF - ON.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-229