Siemens SINUMERIK 840Di Diagnostic Manual page 650

Overview of Alarms
HMI alarms
105023 File %1 exists already !
Parameters: %1 = --
Definitions: The file cannot be copied to this directory, as a file with the same name is already here.
Remedy: --
105024 Check values! - At least 1 value not within input limits!
Definitions: An invalild value was entered in the cycle parameter image.
Remedy: --
105025 Please wait, structuring directory !
Definitions: The data required for the display of the directory is being determined.
Remedy: --
105026 NOTICE! Simulated program not identical to edited program!
Definitions: The program being executed is not identical to the program opened in the editor.
Remedy: --
105027 Selection is being made
Definitions: --
Remedy: --
105028 Selection is impossible
Definitions: --
Remedy: --
105030 Please wait, renumbering in progress (%1)!
Parameters: %1 = --
Definitions: The part program's blocks are serially numbered.
Remedy: --
105031 Renumbering has been aborted !
Definitions: Renumbering of the part program was aborted.
Insufficient part program memory may be the cause of the error.
Remedy: --
105032 Renumbering finished !
Definitions: Renumbering of the part program was completed without errors.
Remedy: --
105033 Renumbering incomplete, max. block length exceeded (%1)
Parameters: %1 = --
Definitions: --
Remedy: --
105041 Block number will be too large !
Definitions: The set increment and the size of the program cause the block number to be greater than 999999.
Remedy: --
2-650
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006