Siemens SINUMERIK 840Di Diagnostic Manual page 216

Overview of Alarms
NCK alarms
14129 Channel %1 block %2 orientation angles and orientation vector
components programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An orientation angle and components of an orientation vector were programmed at the same time.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14130 Channel %1 block %2 too many initialization values given
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: On assigning an array by means of SET, more initialization values than existing array elements have
been specified in the program run.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Reduce the number of initialization values.
Program Clear alarm with the RESET key. Restart part program
Continuation:
14131 Channel %1 block %2 orientation axes and lead/tilt angles programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An orientation angle and a leading or sideways angle were programmed at the same time.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14132 Channel %1 block %2 orientation axes incorrectly configured
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The configuration of the orientation axes does not match the machine kinematics. Also, for example,
when the position measuring system has not been set for the rotary axes.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Adapt machine data.
Program Clear alarm with the RESET key. Restart part program
Continuation:
2-216
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006