Siemens SINUMERIK 840Di Diagnostic Manual page 93

11/2006
8045 Option for selected cycle settings not set
Definitions: The option for the 810D Powerline for activation of the same current/speed/position controller/IPO
cycle time grid as with the 840D is not set. Without the option, only the set values of the 810D Standard
are permitted.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Buy option
- Set (current/speed controller) cycle times to 810D default values.
Program Switch control OFF - ON.
Continuation:
8050 Option 'SPL inputs/outputs' not set.
Definitions: The number of PLC I/Os has not been set in the option date for Solution Line.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select area SI Basic or SI Comfort in the option date.
Program Switch control OFF - ON.
Continuation:
8051 Option 'Handwheel on PROFIBUS' not set
Definitions: The option to operate handwheels on PROFIBUS is not set.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Activate option 'Handwheel on PROFIBUS'
Program Switch control OFF - ON.
Continuation:
8080 %1 option(s) is/are activated without setting the license key
Parameters: %1 = Number of non-licensed options
Definitions: One or more options were activated but no license key was set to prove the purchase of the option(s).
Reaction: Alarm display.
Remedy: Generate license key through the internet under http://www.siemens.com/automation/licence and
enter it in the operating area "Start-up", function (HSK) "Licences".
Program Clear alarm with the Delete key or NC START.
Continuation:
8081 %1 option(s) is/are activated that are not licensed by the license key
Parameters: %1 = Number of non-licensed options
Definitions: One ore more options were activated, that are not licensed by the license key entered.
Reaction: Alarm display.
Remedy: Generate new license key through the internet under http://www.siemens.com/automation/licence
and enter it in the operating area "Start-up", function (HSK) "Licences".
Program Clear alarm with the Delete key or NC START.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-93