Siemens SINUMERIK 840Di Diagnostic Manual page 219

11/2006
14146 Channel %1 block %2 CP or PTP movement without transformation not
allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The CP or PTP G code was programmed for a movement but no transformation was active.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify the program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
14147 Channel %1 block %2 spline for orientation not possible.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If an orientation has been programmed while BSPLINE is active, the interpolation of
tool orientation must be interpolated via a 2nd space curve. This means that G code ORICURVE
must be active for the interpolation of the orientation.
Reaction: Correction block is reorganized.
Interpreter stop
Interface signals are set.
Alarm display.
Remedy: Change the NC program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14148 Channel %1 illegal reference system for Cartesian manual traverse
Parameters: %1 = Channel number
Definitions: In the setting data SC_CART_JOG_MODE, an illegal value has been entered for the reference
system with Cartesian manual travel.
Reaction: Alarm display.
Remedy: Enter a permitted value in the setting data SC_CART_JOG_MODE.
Program Clear alarm with the RESET key. Restart part program
Continuation:
14150 Channel %1 block %2 illegal tool carrier number programmed or
declared (MD)
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A toolholder number was programmed which is negative or greater than the machine data
MC_MM_NUM_TOOL_CARRIER.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Program valid toolholder number or
adapt machine data MC_MM_NUM_TOOL_CARRIER.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-219