Siemens SINUMERIK 840Di Diagnostic Manual page 157

11/2006
12090 Channel %1 block %2 unexpected parameter %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Disallowed parameters in the text
Definitions: The programmed function has been predefined; no parameters are allowed in its call. The first
unexpected parameter is displayed.
Example: On calling the predefined subroutine TRAFOF (switching off a transformation) parameters
have been transferred (one or more).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM
CORRECT. The correction pointer positions on the incorrect block.
Program function without parameter transfer.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12100 Channel %1 block %2 number of passes %3 not permissible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of passes
Definitions: The subroutines called with MCALL are modal, i.e. after each block with positional information a
routine run is automatically performed once. For this reason, programming of the number of passes
under address P is not allowed.
The modal call is effective until another MCALL is programmed, either with a new subroutine name or
without (delete function).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM
CORRECT. The correction pointer positions on the incorrect block.
Program the subroutine call MCALL without number of passes.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12110 Channel %1 block %2 block syntax cannot be interpreted
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The addresses programmed in the block are not permissible together with the valid syntax defining G
function, e.g. G1 I10 X20 Y30 F1000.
An interpolation parameter must not be programmed in the linear block.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM
CORRECT. The correction pointer positions on the incorrect block.
Check the block structure and correct in accordance with the programming requirements.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-157