Siemens SINUMERIK 840Di Diagnostic Manual page 662

Overview of Alarms
HMI alarms
112200 The contour is a step in the current program%nsequence. Machining not
enabled
Definitions: The contour is an element from a loaded program and cannot be deleted or renamed.
Reaction: Alarm display.
Remedy: Remove the contour from the loaded program.
Program Internal
Continuation:
112201 Contour is step in current automatic chain%nMachining not possible.
Definitions: The contour is an element of a program loaded under "Machine auto" and cannot be deleted or
renamed.
After the program has been started, the integrated contours cannot be changed under "Program"
while the program is running.
Reaction: Alarm display.
Remedy: Stop the program and load it under "Program". Remove the contour from the program.
Program Internal
Continuation:
112210 Tool axis cannot be changed. Not enough NC-%nmemory.
Definitions: If the tool axis is reselected, the NC program has to be generated again. Hereby the old NC program
is saved first.
Then the new program is generated. Here, the NC memory is insufficient to save the new program.
The reselection of the tool axis was not carried out.
Reaction: Alarm display.
Remedy: Free memory space must be created on the NC, and it must be enough for the program to be
processed (e.g. by deleting programs that are no longer required).
Program Internal
Continuation:
112211 Tool preselection cannot be processed.%nNot enough NC memory.
Definitions: When tool preselection is processed, the NC program has to be generated again. Hereby the old NC
program is saved first.
Then the new program is generated. Here, the NC memory is insufficient to save the new program.
The tool preselection is not processed.
Reaction: Alarm display.
Remedy: Free memory space must be created on the NC, and it must be enough for the program to be
processed (e.g. by deleting programs that are no longer required).
Program Internal
Continuation:
112300 Tool management concept 2 not possible%nMagazine not completely
loaded.
Definitions: The magazine is not completely loaded with tools.
In the magazine of tool management type 2, the number of tools specified in machine data 18082 has
to be created.
Reaction: Alarm display.
Remedy: Installation and start-up: Create the correct number of tools.
Program Internal
Continuation:
2-662
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006