Siemens SINUMERIK 840Di Diagnostic Manual page 562

Overview of Alarms
NCK alarms
61710 Channel %1 block %2: Stock removal program not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Internal
Continuation:
61711 Channel %1 block %2: Name of stock removal program missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Internal
Continuation:
61712 Channel %1 block %2: Tool parameter for machining direction not
defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Internal
Continuation:
61720 Channel %1 block %2: Incorrect parameter input.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61721 Channel %1 block %2: Error contour direction cannot be determined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
2-562
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006