Siemens SINUMERIK 840Di Diagnostic Manual page 192

Overview of Alarms
NCK alarms
14001 Channel %1 block %2 illegal end of block
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: After system-internal data manipulation (e.g. when transferring blocks from an external source) a
subfile can end without having LF as the last character.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Read out the part program, modify it with a text editor (e.g., insert blanks or comments before the
displayed block), so that after reading it in again the part program has a different structure in the
memory.
Program Clear alarm with the RESET key. Restart part program
Continuation:
14005 Channel %1 block %2 program %3 program-specific start disable has
been set
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Program name
Definitions: Program %3 cannot be executed, as the program-specific start disable has been set for this file.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Reset the program-specific start disable for file %3.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14008 Channel %1 block %2 WRITE command writes in the temporary memory
area in /_N_EXT_DIR
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A workpiece is executed from an external data register (Execute from external drives function). The
part programs are temporarily stored in the NCK directory /_N_EXT_DIR. An attempt is now made to
write in this temporary directory with a WRITE command.
The alarm is intended to indicate that this data is not stored in the original directory on the external
data carrier, and will be lost at the next part program selection because the programs in the directory
/_N_EXT_DIR will then be deleted.
Reaction: Alarm display.
Remedy: State a directory that remains permanently loaded in the NCK as the target for the WRITE command
(e.g. MPF_DIR).
The alarm can be suppressed with machine data 11415 / $MN_SUPPRESS_ALARM_MASK_2 bit 8.
Program Clear alarm with the Delete key or NC START.
Continuation:
2-192
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006