Siemens SINUMERIK 840Di Diagnostic Manual page 146

Overview of Alarms
NCK alarms
10930 Channel %1 block %2 interpolation type not allowed in stock removal
contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The following types of interpolation are allowed in the contour program for stock removal: G00, G01,
G02, G03, CIP, CT
Reaction: Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: In the contour subroutine, program only path elements that consist of straight lines and arcs.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10931 Channel %1 block %2 incorrect stock removal contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The following errors occurred in the subroutine for the contour during stock removal:
- Full circle
- Overlapping contour elements
- Wrong start position
Reaction: Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: The errors listed above must be corrected in the subroutine for the stock removal contour.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10932 Channel %1 block %2 preparation of contour has been restarted
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The first contour preparation/contour decoding run must be terminated with EXECUTE.
Reaction: Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program the keyword EXECUTE to terminate the contour preparation in the part program before again
calling up contour segmentation (keyword CONTPRON).
Program Clear alarm with the RESET key. Restart part program
Continuation:
2-146
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006