Siemens SINUMERIK 840Di Diagnostic Manual page 680

Overview of Alarms
HMI alarms
120309 The selection is not possible. Please close the simulation and repeat the
selection.
Definitions: The simulation is currently active in the program area.
A simultaneous editing is not possible.
Reaction: Alarm display.
Remedy: Close the simulation and make the selection again.
The alarm disappears automatically as soon as a program is edited or simulated in the program area.
The alarm can also be acknowledged manually via diagnostics.
Program Internal
Continuation:
120310 The selection is not possible. Please wait for the pending action or
terminate it, then repeat the selection.
Definitions: In the program area, programs are currently being copied, loaded or unloaded.
A simultaneous editing is not possible.
Reaction: Alarm display.
Remedy: Wait until the action is completed or terminate the action via the softkey "Cancel" and then repeat the
selection.
The alarm disappears automatically as soon as a program is edited or simulated in the program area.
The alarm can also be acknowledged manually via diagnostics.
Program Internal
Continuation:
129900 Data of passive drives are not backed up!
Definitions: This indicates that passive drives are not backed up as well when an upgrade is made.
Reaction: Alarm display.
Remedy: If the drive shall be backed up as well, it must be enabled. If the note shall not be displayed again, set
the drive to "0" in machine data 30240 ENC_TYPE and 30130 CTRLOUT_TYPE.
Program Internal
Continuation:
129901 Time determination is being initialized. Please wait...
Definitions: This indicates that the time determination is being initialized and that the operator shall not yet press
NC Start or execute other operator actions.
Reaction: Alarm display.
Remedy: Not necessary. After completion of the initialization, the dialog box will be faded out again
automatically.
Program Internal
Continuation:
129902 Recorded data are being processed. Please wait...
Definitions: This indicates that data recorded by time determination are currently processed and that the operator
shall not yet press NC Start or execute other operating actions.
Reaction: Alarm display.
Remedy: Not necessary. After completion of the initialization, the dialog box will be faded out again
automatically.
Program Internal
Continuation:
2-680
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006