Siemens SINUMERIK 840Di Diagnostic Manual page 115

11/2006
10707 Channel %1 channel-specific protection zone %2 reached with axis %3
during manual mode
Parameters: %1 = Channel number
%2 = Protection zone number
%3 = Axis name
Definitions: The workpiece-related channel-specific protection zone has been reached with the specified axis.
Note that another tool-related protection zone is still active. The workpiece-related protection zone can
be traversed when the PLC has issued an enable signal.
Reaction: Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Protection zone can be traversed after
enable signal from PLC.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
10710 Channel %1 block %2 conflict with centerless grinding
Parameters: %1 = Channel number
%2 = Spindle number
Definitions: Centerless grinding is active and a block has been processed that satisfies at least one of the following
conditions:
- G96 active and regulating spindle is master spindle.
- Regulating spindle is in interdependent grouping.
- Axes of centerless transformation overlap with an active transformation and a tool is active.
- Constant wheel peripheral speed for the regulating spindle is active.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-115