Siemens SINUMERIK 840Di Diagnostic Manual page 859

11/2006
Error code 0014H
Error text Illegal Opcode, Trace, SWI, NMI (DSP)
Extension 1 Incorrect address
Extension 2 -
Explanation The processor has detected an illegal command in the program memory.
Remedy Replace the control module.
Error code 0015H
Error text Error in checksum test
Extension 1 -
Extension 2 As of Version 4.0: Segment of the faulty code / data area, whereby:
0: P: memory
1: X: memory
2: Y: memory
Explanation A difference has been detected between the setpoint and actual checksums during con-
tinuous testing of the checksum.
The cause is probably a hardware error on the control module.
Remedy Replace the control module.
Error code 0016H
Error text SSI interrupt
Extension 1 -
Extension 2 -
Explanation An illegal processor interrupt has occurred.
The cause is probably a hardware error on the control module.
Remedy Check the drive bus cable and cable connections. Replace the control module.
Error code 0017H
Error text SCI interrupt
Extension 1 -
Extension 2 -
Explanation An illegal processor interrupt has occurred.
The cause is probably a hardware error on the control module.
Remedy Check the drive bus cable and cable connections. Replace the control module.
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Error Codes of Alarm 300500
4-859