Siemens SINUMERIK 840Di Diagnostic Manual page 181

11/2006
12572 Channel %1 block %2 %3 only permissible for motion synchronous
action
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source symbol
Definitions: The predefined subprogram %3 specified here is only allowed in a block with motion synchronous
action. It must not be contained alone in a "normal" block.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12573 Channel %1 block %2 motion-synchronous action: Call by reference
parameters not allowed %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source text area
Definitions: Call by reference parameters (keyword VAR) are not possible with technology cycles.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct PROC instruction of technology cycle.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12580 Channel %1 block %2 %3 not permissible for assignment in motion
synchronous action
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source symbol
Definitions: The variable displayed must not be written in a motion synchronous action. Only selected variables
are permitted here, e.g. DO $AA_IW[X]=10 is not allowed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
Modify part program.
In a motion synchronous action, only certain variables are allowed.
E.g. $AA_IM, $AC_DTGPB
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-181