Siemens SINUMERIK 840Di Diagnostic Manual page 111

11/2006
10652 Channel %1 axis %2 gantry warning threshold exceeded
Parameters: %1 = Channel number
%2 = Axis
Definitions: The gantry following axis has exceeded the warning limit specified in MD 37110
GANTRY_POS_TOL_WARNING.
Reaction: Alarm display.
Remedy: Please inform the authorized personnel/service department.
1. Check axis (uneven mechanical movement?)
2. MD not set correctly (MD 37110 GANTRY_POS_TOL_WARNING). Changes to this MD take effect
after a RESET.
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
10653 Channel %1 axis %2 gantry error threshold exceeded
Parameters: %1 = Channel number
%2 = Axis
Definitions: The gantry following axis has exceeded the error limit (actual value tolerance) specified in MD 37120
GANTRY_POS_TOL_ERROR.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department.
1. Check axis (uneven mechanical movement?)
2. MD not set correctly (MD 37120 GANTRY_POS_TOL_ERROR). A POWER ON is necessary after
modifying the MD.
If the axes are not yet referenced, MD GANTRY_POS_TOL_REF is the trigger condition for the error
message.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10654 Channel %1 waiting for synchronization start of gantry group %2
Parameters: %1 = Channel number
%2 = Gantry unit
Definitions: Alarm message appears when the axes are ready for synchronization. The gantry unit can now be
synchronized. The actual value difference between master and slave axis is greater than the gantry
warning threshold MD 37110 GANTRY_POS_TOL_WARNING. The synchronization must be started
again explicitly with the start gantry synchronization interface signal (DB31-48, DBX 29.4).
Reaction: Alarm display.
Remedy: Please inform the authorized personnel/service department. See Description of Functions (Special
Functions), G1 Gantry Axis
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
10655 Channel %1 synchronization of gantry group %2 in progress
Parameters: %1 = Channel number
%2 = Gantry unit
Definitions: No further explanation.
Reaction: Alarm display.
Remedy: --
Program Alarm display showing cause of alarm disappears. No further operator action necessary.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-111