Siemens SINUMERIK 840Di Diagnostic Manual page 345

11/2006
17600 Channel %1 block %2 preset on transformed axis %3 not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The displayed axis is involved in the current transformation. This means that is it not possible to set
the actual value memory (preset) for this axis.
Example:
Machine axis A should be set to the new actual value A 100 at the absolute position A 300.
:
N100 G90 G00 A=300
N101 PRESETON A=100
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Avoid preset actual value memory for axes which are participating in a transformation or deselect the
transformation with the keyword TRAFOOF.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17605 Channel %1 block %2 axis %3 transformation active: inhibits rotation of
axis container
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The programmed axis/spindle is active in a transformation and the axis container cannot be rotated
for this reason.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program. Deactivate the transformation for this axis/spindle before rotating the axis
container or perform the axis container rotation later.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17610 Channel %1 block %2 axis %3 involved in the transformation, action
cannot be carried out
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The axis is involved in the active transformation. It can therefore not execute the demanded action,
traversing as positioning axis, enable for axis replacement.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Deselect the transformation with TRAFOOF ahead of time or remove the action from the part program
block
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-345