Siemens SINUMERIK 840Di Diagnostic Manual page 89

11/2006
8000 Channel %1 option 'user interrupt programs' not set
Parameters: %1 = Channel number
Definitions: The input signals of NCK inputs are required in order to activate the interrupt routines and rapid lift
from contour. This function is not included in the basic version and must be retrofitted when needed.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Do not use rapid interrupt inputs or
contact the machine manufacturer with a view to retrofitting this option!
Program Clear alarm with the RESET key. Restart part program
Continuation:
8010 Option 'activation of more than %1 axes' not set
Parameters: %1 = Number of axes
Definitions: More machine axes have been defined through the channel-specific MD 20070
AXCONF_MACHAX_USED than are allowed in the system.
Reaction: NC not ready.
Mode group not ready, also effective for single axes
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. The sum of all axes that have been
configured through the channel-specific MD 20070 AXCONF_MACHAX_USED, must not exceed the
maximum number of axes (dependent on configuration -> option, basic version: 4 axes).
Program Switch control OFF - ON.
Continuation:
8020 Option 'activation of more than %1 channels' not set
Parameters: %1 = Number of channels
Definitions: A 2nd channel has been indicated but the corresponding option does not exist.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: In the system-specific MD 10010 ASSIGN_CHAN_TO_MODE_GROUP, reduce the number of
channels to 1 or retrofit the option for a 2nd channel.
Program Switch control OFF - ON.
Continuation:
8021 Option 'activation of more than %1 mode groups' not set
Parameters: %1 = Number of mode groups
Definitions: The option for the number of mode groups is not compatible with the activated mode group.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Add option for more mode groups. Activate fewer mode groups.
Program Switch control OFF - ON.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-89