Siemens SINUMERIK 840Di Diagnostic Manual page 511

11/2006
61187 Channel %1 block %2: block search mode not allowed -> select block
search with contour calculation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The alarm is triggerd by the following cycles: CYCLE800.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select block search with contour calculation.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61188 Channel %1 block %2: No axis name agreed for 1st rotary axis -> Start-up
check CYCLE800
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No axis name was specified for the 1st rotary axis. Alarm triggered by following cycles: CYCLE800.
Remedy: Check installation and start-up of the swivel cycle CYCLE800.
No entry under rotary axis 1 identifier.
61189 Channel %1 block %2: invalid rotary axis positions
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE800.
Remedy: Swivel in JOG, swivel mode direct, check position of rotary axes or start-up of swivel cycle CYCLE800
rotary axes, check area of angles.
61190 Channel %1 block %2: unable to retract in tool direction --> error code:
%4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE800.
Note on 61190
61190 Retraction in tool direction not possible --> error code: %4
Error code %4 = abcd
a=0xxx -> Parameter CYCLE800 _FR incorrect or retraction variant in start-up CYCLE800 not
created.
a=1xxx -> No applicats available $P_AXN3
a=2xxx -> Maximum retraction path incorrect, see GUD _TC_P[8]
a=3xxx -> Incremental retraction path incorrect, see GUD _TC_P[8]
b=Input parameter _FR*100
cd=Start-up parameter $P_TCARR37[] (7th,8th decimal place)
see table Coding retraction modes.
Remedy: Error code: %4
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-511