Siemens SINUMERIK 840Di Diagnostic Manual page 193

11/2006
14009 Channel %1 block %2 illegal program path %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Program path
Definitions: The part program command CALLPATH was called with a parameter (program path) referring to a
directory which does not exist in the file system of the NCK.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: - Modify the CALLPATH instruction such that the parameter contains the complete path name of the
loaded directory.
- Load the programmed directory in the file system of the NCK.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14010 Channel %1 block %2 invalid default parameter in subroutine call
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In a subroutine call with parameter transfer, parameters have been omitted that cannot be replaced
by default parameters (call-by-reference parameters or parameters of type AXIS. The other missing
parameters are defaulted with the value 0 or with the unit frame in the case of frames).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: The missing parameters must be provided with values in the subroutine call.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-193