Siemens SINUMERIK 840Di Diagnostic Manual page 273

11/2006
15380 Channel %1 block %2 illegal incremental programming in axis %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis
Definitions: The first axis programming after "search to block end point" is performed incrementally. This is not
allowed in the following situations:
- After searching the target a transformation change has taken place.
- A frame with rotation component is active. The programmed axis is involved in the rotation.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Find search destination in which the axes are programmed using an absolute reference.
- Deactivate adding of the accumulated search position with $SC_TARGET_BLOCK_INCR_PROG =
FALSE.
- Use search run with calculation "at contour".
Program Clear alarm with the RESET key. Restart part program
Continuation:
15390 Channel %1 block %2 %3 not executed during block search
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source symbol
Definitions: During block search, commands for switching, deleting and defining of the electronic gear are not
executed and not gathered but simply skipped.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Set the desired gear status via asynchronous subprogram.
Program Clear alarm with the Delete key or NC START.
Continuation:
15395 Channel %1 master-slave not executable during block search
Parameters: %1 = Channel number
Definitions: A master-slave coupling is to be closed in the part program via the instruction MASLON. The position
offset $P_SEARCH_MASLD, however, cannot be correctly calculated during block search, as the
axes to be coupled are located in different channels.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Make sure that all relevant axes are in the same channel.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-273