Siemens SINUMERIK 840Di Diagnostic Manual page 226

Overview of Alarms
NCK alarms
14197 Channel %1 block %2 D number and H number programmed
simultaneously
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A D word and H word have been programmed simultaneously.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14198 Channel %1 block %2 illegal change of tool direction with tool offset
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If an offset is active in the tool direction, block change is not possible if this would change the
assignment of the offset axes to the channel axes (plane change, tool change, cutter <=> turning tool,
geometry axis replacement).
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: - Modify part program.
- Reduce the offset in tool direction to zero.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14199 Channel %1 block %2 illegal plane change for tool with diameter
component
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If a tool has a wear or length component which is evaluated as a diameter for the facing axis (bit 0
and/or bit 1 in MD $MC_TOOL_PARAMETER_DEF_MASK is set) and bit 2 of this MD is also set, this
tool may only be used in the plane active on tool selection. A plane change results in an alarm.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: - Modify part program.
- Reset bit 2 in MD $MC_TOOL_PARAMETER_DEF_MASK.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-226
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006