Siemens SINUMERIK 840Di Diagnostic Manual page 238

Overview of Alarms
NCK alarms
14542 Channel %1 block %2 contour tool: the min. limit angle has not been
programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: On defining a contour tool, either no limit angle must be indicated, or both the minimum and the
maximum limit angle must be programmed once for each.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14543 Channel %1 block %2 contour tool: the max. limit angle has not been
programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: On defining a contour tool, either no limit angle must be indicated, or both the minimum and the
maximum limit angle must be programmed once for each.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14544 Channel %1 block %2 contour tool: edge D%3 is not positioned between
the two border edges
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions: On defining a form tool with limit, all edges must be positioned between the edge with the minimum
limit angle and the edge with the maximum limit angle when rotating counter-clockwise.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-238
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006