Siemens SINUMERIK 840Di Diagnostic Manual page 245

11/2006
14710 Channel %1 block %2 error in initialization sequence in function %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Identifier of the function which caused the error
Definitions: Initialization blocks are generated (or not) after control power-up, (program) RESET and (program)
START, depending on the settings in machine data $MC_RESET_MODE_MASK and
$MC_START_MODE_MASK.
Errors can occur because of incorrect machine data settings. The errors are output with the same error
messages as would appear if the function had been incorrectly programmed in the part program.
This alarm is also generated in order to indicate that an error relates to the initialization sequence.
Parameter %3 specifies which function triggers the alarm:
Control power-up and (program) RESET:
Value:
0: Error during synchronization preprocessing/main run
1: Error on selection of tool length compensation
2: Error on selection of transformation
3: Error on selection of work offset
The macro definitions and cycle interfaces are also read in during the power-up procedure. If an error
occurs here, this is indicated by value = 4, or value = 5
6: Error creating 2 1/2 D protection zones during power up.
(Program) START:
Value
100: Error during synchronization preprocessing/main run
101: Error on selection of tool length compensation
102: Error on selection of transformation
103: Error on selection of synchronized spindle
104: Error on selection of work offset
Particularly when tool management is active, it is possible that a tool on the spindle or the toolholder
is disabled but still needs to be activated.
These tools are automatically activated on RESET. On START, machine data
$MC_TOOL_CHANGE_ERROR_MODE can be used to specify whether an alarm is to be generated
or an automatic bypass strategy selected.
If the parameter contains 3 values from 200 to 203, this means that an insufficient number of NC
blocks is available for NC block preparation on certain commands (ASUB start, overstore selection,
teach-in).
Remedy: Increase machine data $MC_MM_NUM_BLOCKS_IN_PREP.
Reaction: Interpreter stop
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
If parameter %3= 0 -3:
If the alarm or alarms occur on RESET:
Check the settings of machine data $MC_RESET_MODE_MASK,
$MC_TOOL_RESET_VALUE, $MC_TOOL_PRESEL_RESET_VALUE,
$MC_TOOL_RESET_NAME (only if tool management is active),
$MC_CUTTING_EDGE_RESET_VALUE, $MC_SUMCORR_RESET_VALUE,
$MC_TOOL_CARRIER_RESET_VALUE,
$MC_GCODE_RESET_VALUES, $MC_EXTERN_GCODE_RESET_VALUES,
$MC_TRAFO_RESET_VALUE,
$MC_COUPLE_RESET_MODE_1,
$MC_CHBFRAME_RESET_MASK
If parameter %3= 100 - 104:
Check the setting of machine data $MC_START_MODE_MASK and the machine data specified
under '..._RESET_...'. If tool management is active, if necessary remove the tool stated in the
associated alarm from the toolholder/spindle and cancel the 'disabled' status.
If parameter %3= 4 or 5:
Check macro definitions in _N_DEF_DIR
Check cycle directories _N_CST_DIR and _N_CUS_DIR
If parameter %3= 6:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-245