Siemens SINUMERIK 840Di Diagnostic Manual page 100

Overview of Alarms
NCK alarms
10226 [up to SW 3.x only] Channel %1: reset aborted
Parameters: %1 = Channel number
Definitions: An error occurred during the reset, with the result that the sequence could not be continued.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Alarm display.
Remedy: Press RESET again.
Program Clear alarm with the RESET key in all channels of this mode group. Restart part program.
Continuation:
10227 [up to SW 3.x only] Channel %1: command aborted
Parameters: %1 = Channel number
Definitions: An error occurred while a command was active, with the result that the sequence could not be
continued.
Reaction: Alarm display.
Remedy: Activate the command again.
Program Clear alarm with the Delete key or NC START.
Continuation:
10230 [up to SW 3.x only] Mode group %2 channel %1 program interruption
does not permit mode change
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: While in the "program interrupted" status (interface signal DB 21 - 28, DBX 35.3) - triggered by an NC
Stop followed by a mode change to JOG - it is only possible to change back to the previous mode
(AUTOMATIC or MDI).
Reaction: Alarm display.
Remedy: You can change the mode via the "program aborted" status (interface signal DB 21 - 28, DBX 35.4) -
triggered by a "reset".
Program Clear alarm with the Delete key or NC START.
Continuation:
10231 [up to SW 3.x only] Mode group %2 channel %1 program stop does not
permit mode change
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: While in the "program stopped" status (interface signal DB 21 - 28, DBX 35.2, triggered by an NC
Stop), it is only possible to change back to continuous program operation (by means of an NC Start).
Reaction: Alarm display.
Remedy: You can change the mode via the "program aborted" status (interface signal DB 21 - 28, DBX 35.4) -
triggered by a "reset".
Program Clear alarm with the Delete key or NC START.
Continuation:
2-100
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006