Siemens SINUMERIK 840Di Diagnostic Manual page 224

Overview of Alarms
NCK alarms
14170 Channel %1 block %2 illegal interpolation type with tool length
compensation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If tool compensation (G43/G44) is activated in language mode ISO_2, the linear type of interpolation
must be active.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14180 Channel %1 block %2 H number %3 is not defined
Parameters: %1 = Channel number
%2 = Block number, label
%3 = H number of ISO mode
Definitions: The specified H number is not assigned to a tool (ISO_2).
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14185 Channel %1 block %2 D number %3 is not defined
Parameters: %1 = Channel number
%2 = Block number, label
%3 = D number of ISO mode
Definitions: The specified D number is not assigned to a tool (language mode ISO_2).
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14190 Channel %1 block %2 H number with G49
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: G49 (select tool length compensation) and an H word not equal to H0 have been programmed
simultaneously.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-224
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006