Siemens SINUMERIK 840Di Diagnostic Manual page 516

Overview of Alarms
NCK alarms
61212 Channel %1 block %2: Wrong tool type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool type is not suitable for machining.
Alarm triggered by following cycles: CYCLE92, CYCLE951, E_DR, E_DR_O1, E_DR_PEC,
E_DR_SIN, E_MI_TXT, F_DR, F_DR_PEC, F_DR_SIN, F_DRILL, F_DRILLC, F_DRILLD,
F_DRM_DR, F_DRM_PE, F_DRM_SI, F_GROOV, F_MI_TXT, F_MT_LEN, F_PARTOF, F_ROU_Z,
F_ROUGH, F_SP_EF, F_TAP, F_TR_CON, F_UCUT_T
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select a new tool type.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61213 Channel %1 block %2: Circle radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed circle radius is too small.
Alarm triggered by following cycles: CYCLE77, E_CR_HEL, E_PI_CIR, E_PO_CIR, E_PO_REC,
F_PI_CIR, F_PO_CIR, F_PO_REC
Remedy: Correct the circle radius, center point or end point.
61214 Channel %1 block %2: No lead programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No lead/helical lead has been entered.
Alarm triggered by following cycles: E_CR_HEL, E_PO_CIR, E_PO_REC, F_PO_CIR, F_PO_REC.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program a lead.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61215 Channel %1 Block %2: Unfinished dimension incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Check the blank spigot dimensions. The blank spigot must be larger than the production part spigot.
Alarm triggered by following cycles: CYCLE76, CYCLE77, E_PI_CIR, E_PI_REC, E_PO_CIR,
E_PO_REC, F_PI_CIR, F_PI_REC, F_PO_CIR, F_PO_REC
Remedy: Check parameters _AP1 and _AP2.
2-516
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006