Siemens SINUMERIK 840Di Diagnostic Manual page 634

Overview of Alarms
HMI alarms
102012 RS232C transmission stopped
Definitions: --
Remedy: --
102013 Error: RS232C running
Definitions: --
Remedy: --
102014 V24.DLL cannot be loaded
Definitions: --
Remedy: --
102015 RS232C ready %1 %2
Parameters: %1 = --
%2 = --
Definitions: --
Remedy: --
102016 Operating area change disabled
Definitions: --
Remedy: --
102017 Please select drive/path for archive
Definitions: --
Remedy: --
103000 No correction block in the NCK
Definitions: The following is valid up to SW 3.x:
The correction block window cannot be opened. No program correction is possible in the operating
mode "Machine".
The following is valid up to SW 4.1:
The correction block window can be opened in the "Stop program" state.
The program that is currently being executed is opened for editing.
The program part that has not yet been recorded by the NCK's
program processing can be changed permanently.
Remedy: --
103001 Selection only possible after enable or in RESET state
Definitions: In order to execute the desired function, the current channel has to be in the RESET state, e.g.
"Program selection".
Remedy: Trigger reset.
103002 Copying to clipboard not possible
Definitions: The NCK rejects a copy-action to the clipboard because, for example, no more memory is available
or the maximum manageable amount of programs has been exceeded.
Remedy: Delete the programs not currently required.
103003 MDI buffer cannot be deleted
Definitions: The NCK rejects a deletion of the clipboard because the clipboard is currently being executed.
Remedy: Wait until the MDI program has been executed or trigger an NC reset.
2-634
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006