Siemens SINUMERIK 840Di Diagnostic Manual page 276

Overview of Alarms
NCK alarms
15800 Channel %1 block %2 wrong starting conditions for
CONTPRON/CONTDCON
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: There is an error in the start conditions for CONTPRON/CONDCON:
- G40 not active
- SPLINE or POLY active
- Unknown machining type programmed
- Transferred machining direction not defined
- Definition of LUDs in incorrect subroutine level
- Transferred circle coordinates
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
15810 Channel %1 block %2 wrong array dimension for
CONTPRON/CONTDCON
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The number of columns for the array created for CONTPRON/CONTDCON does not conform to the
current programming guide.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with the RESET key. Restart part program
Continuation:
15900 Channel %1 block %2 touch probe not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Measure with deletion of distance-to-go
In the part program, an illegal probe has been programmed with the command MEAS (measure with
deletion of distance-to-go). The probe numbers
0 ... no probe
1 ... probe 1
2 ... probe 2
are allowed, whether the probe is actually connected or not.
Example:
N10 MEAS=2 G01 X100 Y200 Z300 F1000
Probe 2 with deletion of distance-to-go
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Include a probe number within the limits given above in the keyword MEAS=... This must correspond
to the hardware connection of the probe.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-276
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006