Siemens SINUMERIK 840Di Diagnostic Manual page 649

11/2006
105014 Error on copying ! %1
Parameters: %1 = --
Definitions: The file could not be copied.
Remedy: --
105015 Error on renaming ! %1
Parameters: %1 = --
Definitions: The file could not be renamed.
Remedy: --
105016 Error on deleting ! %1
Parameters: %1 = --
Definitions: The file could not be deleted.
Remedy: --
105017 Selection possible only after enable or in RESET state %1
Parameters: %1 = --
Definitions: The selected program is either being currently executed or was not yet enabled.
Remedy: --
105018 Error on generating program ! %1
Parameters: %1 = --
Definitions: The program could not be created; there may no longer be sufficient memory.
Remedy: --
105019 Error on opening window ! %1
Parameters: %1 = --
Definitions: The window could not be opened.
System error that should not occur in normal operation.
Remedy: --
105020 Error on closing window ! %1
Parameters: %1 = --
Definitions: The window could not be closed.
System error that should not occur in normal operation.
Remedy: --
105021 Error on generating workpiece ! %1
Parameters: %1 = --
Definitions: The workpiece could not be created.
Remedy: --
105022 Error on enable ! %1
Parameters: %1 = --
Definitions: The program could not be enabled.
Remedy: --
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
HMI alarms
2-649