Siemens SINUMERIK 840Di Diagnostic Manual page 834

List of Action Numbers
No. 13
Explanation Perform a rapid retraction (VDI signal: Digital-analog interface and ASUB interface, for
further actions see Nos. 10, 11, 12, 85, 86).
Cause -
Remedy -
No. 14
Explanation Move tool - only with tool management (PI command).
Cause -
Remedy -
No. 15
Explanation Perform deletion of distance-to-go or axis synchronization (VDI signal: deletion of dis-
tance-to-go or follow-up mode) (follow-up mode: e.g. on activation of axis motion).
Cause 1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
Remedy Abort program
No. 16
Explanation Abort repetition of subroutine (VDI signal: Delete number of subroutine repetitions).
Cause 1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
Remedy Abort program
No. 17
Explanation Abort subroutine processing (VDI signal: Program level abort).
Cause 1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
Remedy Abort program
3-834
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006