Siemens SINUMERIK 840Di Diagnostic Manual page 575

11/2006
62101 Channel %1 Block %2: Milling direction incorrect - G3 is generated
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Synchronous or reverse rotation programmed. But the spindle does not rotate at a cycle call.
Remedy: Check value in paramter CDIR.
62102 Channel %1 Block %2: pocket not completely solidly machined during
finishing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Alarm display.
Remedy:
Program Clear alarm with the Delete key or NC START.
Continuation:
62103 Channel %1 Block %2: No finishing allowance programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No finishing allowance is programmed, although it is necessary for this machining.
Reaction: Alarm display.
Remedy: Programm a finishing allowance.
Program Clear alarm with the Delete key or NC START.
Continuation:
62104 Channel %1 Block %2: Drilling cycle incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Alarm display.
Remedy:
Program Clear alarm with the Delete key or NC START.
Continuation:
62105 Channel %1 block %2: Number of columns or lines equals zero
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE801.
Remedy: Check parameters _NUM1 and _NUM2.
62106 Channel %1 block %2: incorrect value for monitoring status in tool
monitoring
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Alarm display.
Remedy:
Program Clear alarm with the Delete key or NC START.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-575