Siemens SINUMERIK 840Di Diagnostic Manual page 636

Overview of Alarms
HMI alarms
103014 Please first reference axis
Definitions: The reference point approach was not yet performed or finished.
Remedy: Perform reference point approach.
103015 NOTICE! Dimension system is changed from inch to metric
Definitions: --
Remedy: --
103016 NOTICE! Dimension system is changed from metric to inch
Definitions: --
Remedy: --
103017 Scratching impossible due to rotation in %1
Parameters: %1 = --
Definitions: --
Remedy: --
103018 Swivel: Adjustment terminated
Definitions: --
Remedy: --
103019 Swivel: Adjustment not possible
Definitions: --
Remedy: --
104000 Actual tool not found
Definitions: If the cursor in the window "Magazine list" is at a blank line, then no tool will be found after pressing
the softkey "Tool data".
Remedy: Place the cursor on the tool.
104001 No additional tools available
Definitions: After pressing the softkey "T No. +" or "T No. -" the next-highest or next-lowest tool number is
searched for.
If no other tools are available, this message will be output.
Remedy: --
104002 No additional tool edges available
Definitions: After pressing the softkey "D No. +" or "D No. -" the next-highest or next-lowest cutting edge is
searched for.
If no other cutting edges are available,
this message will be output.
Remedy: --
104003 There are no tools
Definitions: No tools were set up.
Remedy: Set up tools.
2-636
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006